Harbor:Equipment: Difference between revisions
(Created page with "==Opening the Suture Cart== X 35280 ==See Also== Harbor: Harbor (Main) Category: Admin") |
|||
| (28 intermediate revisions by 9 users not shown) | |||
| Line 1: | Line 1: | ||
== | ==ED equipment issues<ref>A.Wu Dir AAED 2/14/17</ref>== | ||
For equipment issues, notify the Area Charge RN to report the issue. | |||
Also notify the appropriate director below so they can follow up: | |||
*Cisco phones - notify Charge RN to get replacement phone and Dr. Chappell | |||
*Ultrasound equipment - notify Dr. T. Jang | |||
*AED and RME equipment - notify Dr. Chappell | |||
*PED equipment - notify Dr. P. Padlipsky | |||
*IT equipment, including computers and landline phones - place a ticket by using hospital intranet IT support icon or calling in ticket, and also notifying the appropriate area Director above to follow up. | |||
==iCare<ref>Chappell DIR RME 5-29-18</ref>== | |||
This is the new version of our current model. Quick tips for getting started: | |||
#To turn on, hold the square button on the side about 2 seconds (it will beep when it turns on) | |||
#Insert probe (same as old ones, spares are in the supply room I the special equipment cart); it has a red lens cap to help keep it clean – please replace this after use | |||
#The light turns green on the tip when it is level; there will be a warning on the screen if you are too far or too close to the eye | |||
#Push the arrow to measure … it will average the measurements (discards highest and lowest of 6) and display in green; if there is too much variability, it recommends repeating your measurement. | |||
#Hold the square button down for 2 seconds again to turn it off. | |||
If you get an error message, please email Brad Chappell. | |||
==Teaching Slit Lamp== | |||
*Diagram of How to Use It | |||
==See Also== | ==See Also== | ||
[[Harbor: Harbor | *[[Harbor:Main]] | ||
*[[Harbor:ED supplies A-Z]] | |||
==References== | |||
<references/> | |||
[[Category: Admin]] | [[Category: Admin]] | ||
Latest revision as of 17:39, 12 September 2022
ED equipment issues[1]
For equipment issues, notify the Area Charge RN to report the issue. Also notify the appropriate director below so they can follow up:
- Cisco phones - notify Charge RN to get replacement phone and Dr. Chappell
- Ultrasound equipment - notify Dr. T. Jang
- AED and RME equipment - notify Dr. Chappell
- PED equipment - notify Dr. P. Padlipsky
- IT equipment, including computers and landline phones - place a ticket by using hospital intranet IT support icon or calling in ticket, and also notifying the appropriate area Director above to follow up.
iCare[2]
This is the new version of our current model. Quick tips for getting started:
- To turn on, hold the square button on the side about 2 seconds (it will beep when it turns on)
- Insert probe (same as old ones, spares are in the supply room I the special equipment cart); it has a red lens cap to help keep it clean – please replace this after use
- The light turns green on the tip when it is level; there will be a warning on the screen if you are too far or too close to the eye
- Push the arrow to measure … it will average the measurements (discards highest and lowest of 6) and display in green; if there is too much variability, it recommends repeating your measurement.
- Hold the square button down for 2 seconds again to turn it off.
If you get an error message, please email Brad Chappell.
Teaching Slit Lamp
- Diagram of How to Use It