COVID-19: Resource scarcity: Difference between revisions

(Changed redirect target from COVID to COVID-19)
Tag: Redirect target changed
 
(4 intermediate revisions by 2 users not shown)
Line 1: Line 1:
''This page is for the location/creation/preservation of resources. For hospital protocols for resource ALLOCATION please see [[Hospital preparedness: COVID-19]]''
#REDIRECT[[COVID-19]]
 
==PPE Shortage and Conserving Supplies Guidelines==
In case of PPE shortage or in an attempt to save on PPE supplies, the following guidelines were approved by CDC 3/13/20:
* Same respirator can be worn for multiple serial patient contacts (e.g. in between successive COVID/PUI (patients under investigation) without exchanging respirator. Therefore, in between each patient:
* No need to change mask or eye protection
* BUT need to change gown and gloves
* Respirator reuse possible? Higher risk because of having to touch the mask and either self-inoculate or transmit to another patient (e.g. wear it for a patient, then you remove, and then you put it back on)
* If you must do this because of limited supplies, don and doff properly and perform proper hand hygiene in between
* CDC / NIOSH will allow certain N95s to be used beyond manufacture-designated shelf life
** See list of appropriate models here (manufactured between 2003-2013)
* N95 Reuse? Probably okay to re-use same N95 during an 8 hour shift as long as no tears or visible contamination. Store facedown in labeled re-sealable bag/container.
** Based on non peer reviewed reports from Washington State
 
===Respirators/PAPR===
*N95/KN95/P95/P100/Powered Air Purifying Respirator or equivalent to protect against aerosols
*N95/KN95 respirators- crisis capacity calls for full day/multiple day use
*May be recycled after vaporous hydrogen peroxide treatment
*UV light may be used
*Do not bake in a home oven/use liquids/wash
 
===Eye Shields/Face Shields/Goggles===
*Clean/disinfect and reuse
*Face shields- made by 3d printing or affixing acetate sheets to a foam headband and elastic
 
==Medical Equipment==
===Oxygen Delivery===
*Nasal cannula, Venturi mask, high flow nasal cannula
*Use Y tubing (purchased or 3d printed) to divide oxygen flow to several patients
*Oxygen from portable tanks/wall setup/concentrators
 
===Non-invasive ventilation===
*bpap/cpap-Negative pressure room preferred https://em.umaryland.edu/educational_pearls/3741/
*Decreased aerosolization distance if surgical mask used
 
===Ventilators===
*consider ventilator splitting to ventilate 2 or more patients of similar size and illness
*May need to remove from one patient to give it to another patient https://www.nejm.org/doi/full/10.1056/NEJMsb2005114
 
===Isolation equipment===
 
===IV pumps===
*Use extended tubing so iv pumps can be placed outside patients’ rooms, decreases need for ppe
*Use drop count method if no pumps available/for maintenance fluids
 
==Personnel==
 
 
==See Also==
{{Special:Prefixindex/COVID-19 |hideredirects=1}}
 
==References==
 
 
[[Category:COVID-19]]

Latest revision as of 21:25, 2 February 2022

Redirect to: